Practical Three Roll Rolling Plate

We are a professional manufacturer of Practical three roll rolling plate machines with over 10 years of industry experience. Today, we would like to introduce to you:

The maintenance of the Practical three roll rolling plate machine is the key to ensuring its normal operation and extending its service life. Here are some tips for maintaining a three roll bending machine:

1. Lubrication and maintenance: According to the lubrication diagram of the machine, lubricate each oil cup and manual lubrication point as required. This is an important measure to maintain the flexible operation of various components of the machine and reduce wear and tear. For sliding guide rails, appropriate lubricating oil should be used to ensure smooth sliding; Gears, chains, and other transmission components should also be adequately lubricated. At the same time, attention should be paid to the quality and type of lubricating oil, which should meet the equipment requirements, and the lubrication condition of each lubrication part should be regularly checked, and lubricating oil should be added or replaced in a timely manner.
2. Cleaning work: After the end of each day's work, clean the dust, oil stains, and debris on the surface of the three roll rolling machine to keep the appearance of the equipment clean. In addition, it is necessary to clean the metal shavings, oxide scales, etc. on the roller shaft and workbench to prevent wear and tear on equipment components. Compressed air can be used to blow away debris in the gaps.
3. Tightening inspection: Regularly check whether the bolts and nuts of each connecting part are loose. If they are found to be loose, they should be tightened in a timely manner, including the connecting bolts between the motor and the reducer, the fixing bolts of the roller shaft support seat, etc. At the same time, check if the electrical wiring is secure to avoid faults caused by poor contact.
4. Maintenance of transmission system: Check the tension of the transmission belt of the three roll bending machine. If it is too loose or too tight, it is not conducive to normal transmission. Adjust or replace it if necessary. In addition, it is necessary to regularly check the operating condition of the gearbox, listen for any abnormal noise, and check if the oil temperature is normal.
5. Electrical system maintenance: Regularly clean the dust inside the electrical box to prevent poor heat dissipation of electrical components. At the same time, check whether the connection lines of electrical components are loose and whether the contacts are in good condition.
6. Mold and roller shaft inspection: Check the surface of the mold and roller shaft for scratches, wear, or deformation. If there are any problems, repair or replace them in a timely manner. Regularly straighten and balance the roller shaft to ensure the accuracy of the coil.
7. Trial operation: Conduct a short-term trial operation once a week to check the operation of each part of the three roll plate rolling machine, promptly identify potential problems, and avoid malfunctions during formal production.

8. Standardized operation: After connecting the power, perform both forward and reverse movements of the lower roller and the upward and downward movements of the upper roller, and check for any abnormal jamming in each movement. Strictly follow the coil processing program and operation method for operation, and pay close attention to the safe operation of the equipment when the upper roller is lifted to the limit position. After the main drive of the three roll plate rolling machine stops, operations such as lifting and lowering the upper roll, tilting and resetting the flip bearing, and lifting the upper roll can be carried out. If any irregular noise, impact or other abnormal phenomena are found during operation, the machine should be stopped immediately for inspection. During operation, all personnel should coordinate with each other and follow the instructions of the person in charge of the rolling board. It is prohibited to start the machine without a command.

In addition, when performing the rolling operation, great attention should be paid to preventing hands from being pressed by the steel plate and the steel plate from being rolled in together; When lifting steel plates or drums with a crane, be careful not to collide with the machine. After the rolling process is completed, do a good job of equipment maintenance and promptly turn off the power.

Following the above maintenance tips can effectively extend the service life of the three roll plate rolling machine, improve the stability and work efficiency of the equipment.

If you are interested in the Practical three roll rolling plate machine, please contact us.