Strong Stable Table plasma cutting machine 3015

We are a professional manufacturer of plasma cutting machine equipment with over 10 years of industry experience. Today, we would like to introduce to you:

一、 Preparation work

Firstly, check if the power and gas supply lines of the Strong Stable Table plasma cutting machine 3015 are securely connected to ensure that the equipment is properly connected. Open the gas valve of the plasma cutting machine and adjust the airflow to meet the equipment requirements. Check for any electrical, gas, or water leakage, and ensure accurate connection of the neutral wire. Secondly, place the workpiece and the trolley in the correct position, and the workpiece and circuit should be connected to the positive pole. Install the workpiece fixture to ensure the stability and reliability of the workpiece. There should be a slag pit under the cutting machine to prevent slag splashing. In addition, the nozzle aperture size is determined based on the material, category, and thickness of the workpiece. Adjust various data and select appropriate cutting parameters.

二、 Operation steps

1. Fixed workpiece: Place the workpiece on the workbench and fix it with a fixture.

2. Adjust distance: Adjust the distance between the nozzle and the workpiece plane to 35mm (or 38mm), and adjust the center position of the nozzle to the center position of the workpiece cut.

3. Ignite the plasma arc: Turn on the switch of the plasma cutting machine, turn on the cutting torch switch, and ignite the plasma arc.

4. Start cutting: After cutting the workpiece, move it in the cutting direction at an appropriate speed. Cutting speed is based on cutting, fast but not slow. If it is too slow, it will affect the quality of the incision and even break the arc. During the cutting process, attention should be paid to keeping hands dry and avoiding touching equipment components. At the same time, it is necessary to observe the cutting situation and adjust cutting parameters and positions in a timely manner to achieve the desired cutting effect.

5. Turn off the equipment: After completing the cutting of the entire workpiece, turn off the switch of the plasma cutting machine and extinguish the plasma arc. At this point, the compressed air is delayed in spraying to cool the cutter. After a few seconds, the spraying will automatically stop. Then turn off the gas and water sources, unplug the power and gas cables.

6. Follow up cleaning: Remove the workpiece fixture, clean the workbench and guide rails, etc.

三、 Precautions

1. Operating standards:

During the operation, excessive force or collision with equipment components should be avoided to avoid damaging the equipment or causing safety accidents. When it is necessary to switch the "cutting thickness selection" switch, be sure to turn off the power switch of the host first to prevent damage to the components. When the plasma cutting machine is not in use for a long time, the power switch should be turned off and the power and gas supply lines should be unplugged to save energy and extend equipment life.

2. Maintenance and upkeep:

Regularly clean and maintain the equipment, including cleaning the workbench and guide rails, checking the wear of nozzles and electrodes, etc. If any equipment malfunction or abnormal situation is found, professional personnel should be contacted in a timely manner for maintenance and handling.

3. Environmental requirements:

The working environment should be kept clean and well ventilated to avoid harmful gases and dust from affecting the health of workers. When working in cold environments, it is important to check the operation of the water cooling system to prevent damage to the water-cooled cutting torch due to the malfunctioning of the circulating water cooling system.

In summary, the use of plasma cutting machines requires strict adherence to operating standards to ensure cutting quality and operational safety. At the same time, it is also necessary to do a good job in equipment maintenance and upkeep to extend the service life of the equipment and improve work efficiency.

If you need or are interested in Strong Stable Table plasma cutting machine 3015, please feel free to contact us and we will provide a detailed introduction and quotation for suitable machines.