High Production Efficiency Mechanical Punching Machine

We are a professional High production efficiency mechanical punching machine manufacturer with over 10 years of industry experience. Today, we would like to recommend:

High production efficiency mechanical punching machine , as an important processing equipment, play a crucial role in modern industrial production. Understanding its classification, characteristics, safe operation and maintenance, as well as popular products and solutions in the market, is of great significance for improving production efficiency and product quality.

The specific steps are as follows:

1. Preparation work
Before replacing the mold, it is necessary to ensure that the mechanical punch has stopped running and the power supply has been cut off. This is to ensure operational safety and avoid accidental injuries during mold replacement.
2. Measurement and adjustment
Firstly, it is necessary to measure the height of the mold and adjust the machine's closing height based on the mold's closing height and other parameters. Typically, the closing height can be set slightly higher first, and then adjusted to the appropriate position after installing the mold. It should be noted that the closing height should not be too low to avoid damaging the mold.
3. Install the mold
Before installing the mold, a silicon steel sheet should be placed between the upper and lower molds to prevent damage to the cutting edge during handling. At the same time, it is necessary to use an oilstone to grind off the burrs on the bottom and top surfaces, and clean up the garbage. These preparations can prevent burrs from exceeding the tolerance during the punching process.
4. Adjust the mold closure
Combine the upper and lower molds of the mold together, then use a handwheel pulley to lower the slider of the punch press to the bottom, adjust the distance between the mechanical punch press table and the height of the mold, then put the slider back on top, push the mold forward, align the mold handle with the mold handle mounting hole of the slider, and then lower the slider to the bottom dead center. Use a special wrench to adjust the slider adjustment screw to press the slider onto the support surface of the mold, and tighten the screw after tightening it.
5. Inspection and testing

After installation and adjustment, move the flywheel by hand and test punch twice to ensure that the mold is installed correctly and the punching machine runs normally. In addition, it is necessary to check whether the fastening screws of the mold installation base are locked correctly.

By following the above steps, you can effectively replace the mold of the High production efficiency mechanical punching machine. Please note that safety operating procedures must be strictly followed throughout the entire process to ensure the safety of personnel and equipment.

If you need or are interested in High production efficiency mechanical punching machine, please feel free to contact us and we will provide a detailed introduction and quotation for suitable machines.